| Nama Pengarang | : | - |
| Nama Majalah/Jurnal | : | Majalah Farmasi Indonesia = Indonesian Journal of Pharmacy |
| Volume / Nomor Edisi | : | 18 (No. 1) |
| Nomor Halaman | : | 21-28 |
| Abstraksi Narasi | : | Temulawak (Curcuma xanthorrhiza Roxb.) is one of natural drugs spread throughout Indonesia. Based on researches and experiences, temulawak has been proven to cure some diseases. This research applied combination of sodium citrate and fumaric acid as excipients to produce effervescent granule with certain physical characteristics. The aims of this research were to observe dominant factor and the interaction effect between sodium citrate and fumaric acid, to find out the optimal area of sodium citrate and fumaric acid mix to produce effervescent granule which fulfill the granule requirements. The research used factorial design method with two factors and two levels. The physical characteristics of effervescent granule, evaluated were moisture content, flow rate and time to disintegrate and sdissolve. The results showed that sodium citrate dominant in moisture content and time, whereas fumaric acid dominant in granule flow properties. Under research circumstances, contour plot superimposed fail to show the optimum area for mositure content, flow rate and time to disintegrate and dissolve of effervescent granule cant be obtain from contour plot superimposed under the research condition. |
| Nama Pengarang | : | - |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 241-246 |
| Abstraksi Narasi | : | A swing hanged bar on the twin swing has a shearing stress and a bending stress in connection with the effect of load. This construction was analyzed with a statically indeterminate and the results were: the biggest of shearing stress was on the tip of bar, and the biggest of bending stress was on the middle of bar. The construction of bar as a vertical T profile or an upside-down T profile does not change the value of the shearing stress and the bending stress. |
| Nama Pengarang | : | Ign. Luddy Indra Purnama |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 235-240 |
| Abstraksi Narasi | : | In linear dynamic approach of production system, the wip (work in process) performance are stable. This paper discusses the modeling of production system with non-linear dynamic approach. A model of an elementary production system is work in process. Some simulation results are given. |
| Nama Pengarang | : | Laila Nafisah |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 223-234 |
| Abstraksi Narasi | : | The concept of public logistics terminals (nmulti company distribution centers) has been expected to help alleviate traffic congestan, environment, energy and labor costs. These facilities allow more efficient logistics systems to be established and facilitate the implementation of advanced information systems and cooperative freight systems. In this research, developed choises distribution warehouse location model from several feasible sites. The problem approach that used in this developing model are integrated planning and control, single cycle policy, and echelon stock concept. The performance criteria that used are total cost and service level. And variable decision in this model are lot size. ordering of product at central distribution warehouse, lot size ordering of product at consolidation distribution warehouse, frequency ordering at consolidation distribution warehouse, and consolidation distribution warehouse location that told by binery variable (0,1). The model is non-linear mix integer programming with binary variable. By having binary variable make the problem becomes complicated so to get the optimal solution by analytical solution is not easy. Therefore, genetic hybrid algorithm is used as solution procedure to obtain an approximate optimal solution. |
| Nama Pengarang | : | Kusworo Anindito |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 213-222 |
| Abstraksi Narasi | : | Peer-to-peer computing opens possibilities to a wide range of new applications such as dynamic and distributed search, distributed content storage and management, massively parallel and distributed processing. Using a peer-to-peer system to share a distributed database needed by many users over a network has many benefits and especially to increase network performances. There are more than one choice of software architecture to implement a peer-to-peer system. Different circumtances and environments may be best with different peer-to-peer architectures. In this paper, we propose a peer-to-peer architecture that is suitable with a condition where there is only one file that is to be shared across multiple client and the main purpose is to speedy the sharing process. |
| Nama Pengarang | : | Christina Avanti |
| Nama Majalah/Jurnal | : | Majalah Farmasi Indonesia = Indonesian Journal of Pharmacy |
| Volume / Nomor Edisi | : | 18 (No. 1) |
| Nomor Halaman | : | 15-20 |
| Abstraksi Narasi | : | The formation of solid-solid dispersion of tretinoin which is insoluble in water into water soluble carrier PEG, might accelerate solubility and dissolution rate. The objectives of this study were to obtain dissolution profile and physical properties of Tretinoin-PEG solid dispersion which was prepared by solvent-fusion method, to obtain the composition of tretinoin and PEG in which produce solid dispersion with optimum dissolution rate and to obtain the composition of tretinoin-PEG, which produce an interstitial solid-solid solution. Solvent-fusion method at low temperature was chosen to prepare the solid dispersion system. The physical state of formed solid dispersion was determined by X-Ray diffractometer. To unveil the information about solubility and dissolution rate of tretinoin, a test toward the dissolution rate of tretinoin was performed into the dissolution medium phosphate buffer. The X-Ray diffractogram of tretinoin-PEG solid dispersion in all composition indicated that tretinoin has formed a molecular dispersion in the PEG crystals in all composition. In solid dispersion was obtained by solvent-fusion method in molecular or in solid-solid solution. Dissolution efficiency (DE) value proved that molecular dispersion of tretinoin-PEG could increase the dissolution rate of tretinoin. Thus it could concluded that in comparison to the tretinoin and its physical mixture, the solid dispersion of tretinoin-PEG lead the higher dissolution rate and the optimum rate was achieved by composition of 1=100 with DE value =74. |
| Nama Pengarang | : | - |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 205-212 |
| Abstraksi Narasi | : | Rapid development of information technology has been reaching every aspect of human daily life, industrial and trades are no exception. Many companies started doing data exchange with their suppliers, consumers and other companies. Data exchange is not done using a printed media anymore but conducted using electronics data with a specified format. One of the well-known formats for the electronic data is XML XML is a mark up language that has widely been accepted as the standard for data exchanging in the Internet. The exchanged data is usually the transactional data being stored in a database. Therefore, such data exchange needs software that is able to convert data form a specified database format to XML. format and vice versa. This research built the Inter-Databases Data exchanging System using XML (Sistem Pertukaran Data Antar Basis Data dengan XML) which is able to convert data from a various database to the corresponding XML file and vice versa. It runs on Windows platform mainly for Microsoft Access, Microsoft SQL Server and Oracle. This software is also provided with a database management utility that will accommodate the database administrator to manage the database. Development of this software was carried out using Object Oriented Software Development (OOSD) approach. |
| Nama Pengarang | : | - |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 195-204 |
| Abstraksi Narasi | : | Searching for underground water in Karst area is a long and tedious underbreaking requiring varied and accurable data. This research was prepared to display cave data as part of an effort to search for underground water in Pacitan county. The preliminary step is the collection of prelimanary geographical map of the area to researched. The next step is the mapping of distribution of cave openings, channels and photographic documentaton. The information is generated in the forms of tables and maps. Information in the forms of maps facilities easier application of the systems in understanding all data available to support planning and decision making. |
| Nama Pengarang | : | Yuwaldi Away,Mohammad Asmady Bin Dawari |
| Nama Majalah/Jurnal | : | Jurnal Teknologi Industri |
| Volume / Nomor Edisi | : | IX-3, JULI (No. 1) |
| Nomor Halaman | : | 183-194 |
| Abstraksi Narasi | : | This research is a part of development phase of Automated Grading System of Technical Drawing (called: SPOT). The objective of this research is to determine an effective and efficient method to extract geometry data that used by SPOT to identify entity of technical drawing. The system is developed through waterfall model, we are designed the detail system, subsystem, module-module and object modeling. The main result is successfulness to extract and identify all of important information from geometry data with visual method. The prototype of SPOT system is implemented and output of sistem already tested and validated. This result very useful as a base of whole successfully process to develop Automated Grading System. |
| Nama Pengarang | : | Sudjadi,Lucia D. Witasari,Modesta T. Sadarum,Nia Nastity,Sismindari |
| Nama Majalah/Jurnal | : | Majalah Farmasi Indonesia = Indonesian Journal of Pharmacy |
| Volume / Nomor Edisi | : | 18 (No. 1) |
| Nomor Halaman | : | 8-14 |
| Abstraksi Narasi | : | Most purification approaches of Ribosome-inactivating Proteins (RIPs) used a cation exchange chromatography resulting highly basic proteins, such as MJ-30 isolated from Mirabilis jalapa leaves. The M. jalapa unbounded protein fractions of the column showed cleavage activity on supercoiled double stranded DNA and possesed cytotoxic effects on cancer cell lines. So the purification and characterization of the acidic protein was needed to be done. Total proteins of M. jalapa leaves was collected from precipitating process of the extract using ammonium sulphate until saturated. After dialysis, the proteins was applied into the weak base anion exchanger Ionenaustaucher type II. The bounded proteins was eluted with 0.0 to 0.5 M NaCl gradient in phosphate buffer. Active protein fractions were determined by supercoiled DNA cleavage activity and then cytotoxic activity was tested. Results showed that protein fraction eluted at 0.35-0.40 M NaCl possesed cleavage activity on supercoiled DNA. The acidid protein, MJ-C, was toxic on HeLa, myeloma, and T47D cell lines, with the LC50 of 14.3 μg/mL, 7.4 μg/mL, and 27.8 μg/mL, respectively. The MJ-C was more potent than the basic protein MJ-30. |